Mapei handles the full sequence from substrate prep through finished surface on renovation floors, wet rooms and repair work. We install Mapei self-leveling, waterproofing and bonding systems as a complete chain, not as separate products. That means every layer bonds to the next one by design, not by luck. Free written estimate on every job.
When a renovation floor needs to be dead flat before tile, vinyl plank or stone goes down, Mapei self-leveling (Ultraplan and Novoplan) is the product that gets there. It flows to a level surface, cures hard, and takes any finish without showing the old slab underneath.
Wet rooms and below-grade slabs need a waterproofing membrane that bonds into the tile system above it. Mapei waterproofing is engineered to tie into Mapei thinset and adhesives, so the whole assembly is one continuous barrier. When concrete is cracked or damaged, Mapei repair mortars and adhesives patch and restore the surface to working strength.
The reason we stick with one product family is simple: every joint between layers is a failure point. Mapei primer, leveler, membrane and adhesive are all formulated to bond to each other, which is the same logic we apply to patio work and other brand systems.
On the job
Installation sequence
Installing Mapei Systems in Las Vegas, Step by Step
Assess the slab and select the Mapei line
We evaluate the substrate condition, moisture levels and what finish will sit on top, then specify the correct Mapei product family for that application.
Mechanically profile and prime
The concrete slab is ground or scarified to the Mapei spec, moisture-tested, and primed with the Mapei primer formulated for that product line.
Mix, pour and finish per spec
Mapei products are mixed to the published water ratio, applied at the temperature the spec requires, and finished in the sequence the system calls for.
Document cure and hand off
Each layer cures on the Mapei schedule, the installation is photographed and documented, and you receive the product data sheets for warranty and future reference.
System thinking
Why One Mapei Family Beats Mixing Brands
Floor failures almost always start at a layer boundary, where one product fails to bond to the product below it. When you use a single brand family, that variable disappears. Mapei primer is designed to bond to Mapei leveler, which bonds to Mapei waterproofing, which bonds to Mapei adhesive. No surprises.
Self-leveling, waterproofing, system compatibility and what Mapei does best in Las Vegas.
Mapei Ultraplan and Novoplan are tested, predictable products with deep installer support. They pour to a flat, sound surface that takes a finish without telegraphing the slab below, which is exactly what a renovation needs.
Yes, that is one of its strengths. Mapei waterproofing membranes are designed to bond into Mapei thinset and tile adhesives, so the wet-area floor is one continuous system instead of a stack of unrelated layers.
Because every layer boundary is a place where bond failure can happen. Using a single product family means primer, leveler, waterproofing and adhesive are engineered to work together, removing the surprise bond issues.
Yes, when prep is done right. Mapei repair and adhesive products bond patched and existing concrete back to performance spec when the substrate is mechanically profiled and primed correctly.
Yes. We install the published Mapei system, primer, body, finish, in the correct sequence and at the temperature and mix ratio the spec calls for, so the product warranty stays intact.
A renovation floor that needs to be flat, a wet-room waterproofing, or a repair that ties into a finish. Tell us the project and we will spec the right Mapei products and send a written quote.
